At the top of the web page you need to select the Task Scheduler number, the maximum number of job scheduler is set in the constructor of the firmware prior to assembly.
To use the Task Scheduler in the firmware NTP support or RTC clock must be set.
The requirement is for the time, as well as, if set calendar support and days of the week when the task should be triggered.
In the "mode" you must specify the required task.
I consider that if the module has been switched off, the task will not be performed at the time of processing tasks. For such applications, you must use logic module (Logic2)
The Task Scheduler settings, you must select the task GPIO, in the GPIO NUM field GPIO point number, and the State field to specify the required condition for setting to 0 or 1.
The Task Scheduler settings, you must select the task PWM, GPIO NUM field to specify PWM number (number of the GPIO and PWM room!), And in the State field to specify the required condition for setting from 0 to 255.
The Task Scheduler settings, you must select the Restart task. The value of other parameters is not important.
The Task Scheduler settings, you must select the Display task. In the State specify 1 or 0, depending on the desired task - to enable or disable.
Not suitable for TFT Display - here it is necessary to control via GPIO signal input on the LED display.
In the settings you need to select the Task Scheduler SMS / Email send task. In the State field indicates the number of the firmware option Template SMS / Email templates.
The Task Scheduler settings, you must select the task Matrix. In the State specify the desired brightness from 0 to 15.
The Task Scheduler settings, you must select the Ping task. In the State Specifies whether state 1 or 0.
The function can be used to turn off SMS notifications at night.
The Task Scheduler settings, you must select the task WOL. In the State field indicates the recording the MAC addresses in the settings WakeOnLan function.
The Task Scheduler settings, you must select the task FM Radio, in the GPIO NUM specify the number of stations in FM radio settings.
Not supported new thermostat.